Hardware compatibility
All computers with DisplayPort, USB, audio, RS232 - requirement dependent.
DisplayPort interface
The system supports resolutions to a maximum of 2560 x1600 or two 1920 x1200 screens. The receiver unit supports DisplayPort Dual Mode (DP++) also. DPCP and HDCP are not supported.
USB 2.0
Supports up to six USB 2.0 devices (low or full speed). The system does not allow non-HID devices on ports marked "A". Isochronous devices are supported (i.e. USB audio or video devices) on the Hi-Speed link only marked "B".
Digital stereo audio
The system delivers analog stereo audio (Line in, Line out) and supports microphone input and headphones. It also delivers S/PDIF (optical input) via a 3.5mm jack line in connector (mini Toslink).
RS232
RS232 can be passed between the units to a maximum baud rate of 115K2 via the options port.
Software compatibility
All known operating systems.
Computer connections Transmitter (TX)
DisplayPort x 2, Audio 3.5mm in, Audio 3.5mm out, USB type B x 2 , RS232 10p10c options port.
Peripheral connections Receiver (RX)
DisplayPort ++ x 2, Audio 3.5mm in, Audio 3.5mm out, Headphone 3.5mm out, Microphone 3.5mm in, USB type A x 4, RS232 10p10c options port.
Physical design
1U compact case, robust metal construction. 198mm/7.92" (w), 44mm/1.76" (h), 120mm/4.8" (d), 0.75kg/1.65lbs.
Power
2.5mm DC jack (power adapter included), 100-240VAC 50/60Hz, 0.8A, input to power adapter, 5VDC 20W output from power adapter.
Operating temperature
0 to 40ºC / 32 to 104ºF.
Approvals
CE, FCC
Important Extension distance Information
Recommended cables are CAT7 shielded foiled twisted pairs: Daetwyler 7702 Flexible patch cable Daetwyler 7120 Bulk cable
Resolution | Cable Type | Patch connections | Distance |
2560x1600@60Hz or two 1920x1080@60Hz | CAT7 Bulk (trunk) | 0 | 100 metres |
2560x1600@60Hz | CAT7 Patch | 2 | 80 metres |
2560x1600@60Hz | CAT6a | 2 | 70 metres |
2560x1600@60Hz | CAT5e | 2 | 60 metres |
Single 1920x1080@60Hz | CAT5e | 2 | 150 metres |
Note:
Distances are achieved using single lengths of trunk/bulk cable with two 3 meter CAT7a patch cables. For each additional break/patch connection reduce distance by 5 meters. Preferably patch cables should be of type CAT7a and less than 2 meters. Patch cables over 2 meters must be CAT7a.